ConformsTo
IEC60884-1Figure28, VDE0620 Bile 29, EN50075Fig9, BS1363 Fig 9
Plug Pin Abrasion Tester (Model:SFT S2-1309)
Application
The test apparatus comprises a horizontally disposed beam, whichis pivoted about its center point. A short length of steel wire, 1 mm indiameter and bent into a U-shape, the base of the U being straight, is rigidlyattached, at both ends, to one end of the beam, so that the straight partprojects below the beam and is parallel to the axis of the beam pivot.
The plug is held by a suitable clamp in such a position that thestraight part of the steel wire rests on the plug pin, perpendicular to it. Thepin slopes downwards at an angle of 10° to the horizontal.
The beam is loaded so that the wire exerts a force of 4 N on thepin.
The plug is moved backwards and forwards in a horizontal directionin the plane of the axis of the beam, so that the wire rubs along the pin. Thelength of the pin thus abraded is approximately 9 mm, of which approximately 7mm is over the insulating sleeve. The number of movements is 20 000 (10 000 ineach direction) and the rate of operation is 30 movements per minute.
The test is made on one pin of each specimen.
After the test, the pins shall show no damage which may affectsafety or impair the further use of the plug, in particular, the insulatingsleeve shall not have punctured or rucked up.
Conforms To
IEC60884-1 Figure 28 Clause24.7, VDE0620 Bile 29, EN50075Fig 9, BS1363 Fig 9
Specifications
A, Power Supply: 220V 50Hz or 115V 60Hz
B, Number ofTest: 1-999999
C, Rate ofAbrading: 30±1 movements per minute
D, Load: 4N
E, Angle offixture: 10°
E, Number ofTest Station: 1 or 2 or 3 options
F. Outer Dimensions: 570mm*360mm*450mm
G. Weight: 50KG
OrderingInformation
SFT S2-1309Plug Pin Abrasion Tester (one test station) - 220V 50Hz or 115V 60Hz
SFT S2-1309APlug Pin Abrasion Tester(two test stations) - 220V 50Hz or 115V 60Hz
SFT S2-1309BPlug Pin Abrasion Tester(three test stations) - 220V 50Hz or 115V 60Hz
